px4_fw.config 1.02 KB
#!/bin/sh
# PX4 commands need the 'px4-' prefix in bash.
# (px4-alias.sh is expected to be in the PATH)
. px4-alias.sh

# navio config for FW

if [ -f eeprom/parameters ]
then
	param load
fi
param set CBRK_SUPPLY_CHK 894281
param set SYS_AUTOSTART 2100
param set MAV_TYPE 1

# Multi-EKF
param set EKF2_MULTI_IMU 2
param set SENS_IMU_MODE 0

dataman start

load_mon start

mpu9250 -s -R 2 start
lsm9ds1 -s -R 4 start
lsm9ds1_mag -s -R 4 start
ms5611 -X start

navio_rgbled start

board_adc start
battery_status start

gps start -d /dev/spidev0.0 -i spi -p ubx
ms4525_airspeed start -X
rc_update start
sensors start
commander start
navigator start
ekf2 start
land_detector start fixedwing
fw_att_control start
fw_pos_control_l1 start

mavlink start -x -u 14556 -r 1000000 -p

if [ -c /dev/ttyUSB0 ]
then
	mavlink start -x -d /dev/ttyUSB0
elif [ -c /dev/ttyAMA0 ]
then
	mavlink start -x -d /dev/ttyAMA0
fi

navio_sysfs_rc_in start
linux_pwm_out start
mixer load /dev/pwm_out etc/mixers/AETRFG.main.mix

logger start -t -b 200

mavlink boot_complete